DROPS Children 49 · Lots of new kid designs!

Button holes, vertical

These vertical buttonholes are in a double-knit stockinette band. Because it's double knit, the band may be too thick if it's heavier than fingering, but we are using a DK weight to show the technique better. The body of the sweater can be any yarn, just match the yarn for the band.
The hole is built around a small length of yarn the same as the band.
Put as many sts on the doubled extra yarn to match width of the button, start and stop with a P st.
Then cast on the same number of sts as replacement around the other side of the extra yarn. After you worked a few more rows, take the 2 open ends on the extra yarn and pull trough loop, and then tighten up the hole, don't over tighten, then ends are weaved in later.
For more details about the double knitted band, watch our video for Double-knit stockinette band
Change language:

Video #268, listed in: Learn to knit, Knitting tips & tricks, Knitting Bands and Buttonholes

Our videos do not have sound. We are a worldwide company and our videos are watched by people speaking endless of different languages and many do not understand English. So since there is not a given language for us to use, we instead have written instructions to accompany the video, and then there is no sound to disturb while watching.

You can adjust the speed of this video by clicking on the icon, on the play bar.

Country flag MANADIN wrote:

Bonjour cette vidéo est exactement ce que je cherchais .. j'essaie de faire des boutonnières sur un point un peu spécial .. pourriez vous me dire ou trouver l''aiguille qui est utilisée sur cette video... merci d'avance

29.04.2024 - 09:27

DROPS Design :

Bonjour Mme Manadin, pour avoir les bonnes mesures rien de tel que de faire votre propre échantillon qui correspondra à votre tension plutôt que de suivre la taille des aiguilles de la vidéo qui ne fait que montrer comment procéder. N'hésitez pas à tester différentes tailles d'aiguilles jusqu'à ce que vous trouviez la taille idéale. Bon tricot!

29.04.2024 - 14:29

Country flag Mari Soldevilla Larroy wrote:

Queda GENIAL!! Muchas gracias!!!

12.01.2024 - 10:14

Country flag Lelletta wrote:

Buonasera, video perfetto come al solito, ma vorrei chiedere se questa tecnica si può applicare anche su una semplice lavorazione a coste . Grazie mille e buon lavoro!

22.10.2023 - 22:35

DROPS Design :

Buonasera Lelletta, questa tecnica è applicata ad un bordo doppio. Buon lavoro!

19.11.2023 - 20:14

Country flag Petra wrote:

Endlich brauch ich nicht mehr diese Rippenkanten an Jacken machen. Das ist das schönste Knopfloch das ich je gesehen habe, wirkt sehr professionell vor allem in Verbindung mit der doppelten, glatten Borte. Werde ich gleich an meiner nächste Jacke anwenden und hoffe es gelingt mir ebenso gut. Danke für die sehr gute Beschreibung!

03.01.2023 - 09:34

Country flag PelusaWoman wrote:

That's an interesting and neat-looking way to do a horizontal buttonhole, but it sure isn't a vertical one! A vertical buttonhole would be vertical to the direction of knitting, no matter what direction you're working on the sweater.

03.05.2021 - 18:24

Country flag Dauvin wrote:

Bravo!!! Je suis en admiration...je me demande, si je vais y arrivé Merci

24.03.2021 - 08:35

Country flag Styuszrtyrzty wrote:

Ok merci

08.03.2019 - 18:23

Country flag Styuszrtyrzty wrote:

C\'est horizontale et non verticale

07.03.2019 - 19:05

DROPS Design :

Bonjour Mme Styuszrtyrzty, elles sont effectivement faites à l'horizontale, mais le long d'une bordure devant = la boutonnière sera ainsi en hauteur à la fin. Bon tricot!

08.03.2019 - 08:24

Country flag Willemien wrote:

Erg mooie oplossing, thank you!

27.05.2017 - 00:28

Country flag Christine wrote:

Diese Blende sieht sehr hochwertig aus, werde ich sicher mal probieren. Vielen Dank für dieses informative Video.

10.03.2016 - 15:20

Leave a comment or question to this video

Your email address will not be published. Required fields are marked *.

You might also like

Video thumbnail for Double knit stockinette band
5:56
Double knit stockinette band

We are using a DK weight yarn, and it's best not using a heavier yarn than that, rather a smaller like a fingering, even if your garment is in a thicker yarn. From RS pick up appropriate no of sts from the edge of your garment. Since we use a DK weight and a size 7 needle, we are picking up approx 5 sts per inch. If using a fingering weight use a size 2 needle and pick up approx 7-8 sts per inch. Firsts row (WS): k1tbl, *yo, k1tbl*, repeat *-* to end of row. Sts on needle are doubled. 2nd row (RS): knit all yo and slip the purls with yarn in front. 3rd row (WS): knit all slipped sts and slip the purls with yarn in front. Continue like row 3 to desired width on band. Bind off from WS by P2 tog, P2tog, slip the preceding st over as a normal bind off.
Video thumbnail for How to work a diagonal shoulder, cast on stitches for the neckline and work the back piece together
21:11
How to work a diagonal shoulder, cast on stitches for the neckline and work the back piece together

In this DROPS video, we show you how to work each front piece with diagonal shoulders and short rows, the piece is worked bottom up. Then we show how to increase stitches for the neckline and join the shoulders for the back piece, then continue working top down. An I-cord band is worked on each side. We have already worked one section of the front piece and decreased stitches for the neckline. The video shows how we work 6 short rows (German short rows) on the right front piece, creating a diagonal shoulder. Then we show how to increase 1 stitch 3 times towards the neckline, which is now the back piece. Then we show the same for the left shoulder and finally cast on 12 stitches between the shoulders before the shoulders are knitted together. We use the yarn DROPS Snow in the video. This technique is used among other things in pattern DROPS 255-9, Driftwood Vest, with a different stitch count, number of short rows and cast-on stitches. You will find the pattern by clicking the picture below:
Video thumbnail for How to work a double knitted band without buttonholes
7:38
How to work a double knitted band without buttonholes

In this DROPS video we show how to work double band without buttholes. Pick up stitches at the top of the piece / by shoulder on front piece, pick up 1 stitch in every knitted row down along the piece or skip every 4-5 stitch, inside 1 edge stitch. Look at your pattern what it says. After the pick up cast on 12 stitches for band (= at the bottom of the piece), but it can be different from pattern to pattern. Work band over the 12 stitches at the same time as band is knitted together with stitches picked up along the piece as follows: ROW 1 (= wrong side): Knit 1, * slip 1 stitch on to right needle purlwise with strand in front of piece, knit 1 *, work from *-* until 1 stitch remains of the 12 band stitches, slip the next 2 stitches on to right needle purlwise with strand in front of piece, turn. ROW 2 (= right side): Knit 2 together, *, slip 1 stitch on to right needle purlwise with strand in front of piece, knit 1 *, work from *-* until 1 stitch remains, slip last stitch on to right needle purlwise with strand in front of piece, turn. Repeat rows 1 and 2. We use the yarn DROPS Snow in the video. You must read a pattern to be able to follow this video properly. You’ll find a pattern using this technique by clicking on the pictures below.
Video thumbnail for How to work a double knitted band with buttonholes
14:14
How to work a double knitted band with buttonholes

In this DROPS video we show how to work double band with buttonholes. Pick up stitches along right front piece, with a long yarn end to pick up stitches with. Begin pick up at the bottom of front piece and pick up 1 stitch in every knitted row along the entire front piece or skip every 4-5 stitch, inside 1 edge stitch. Look at your pattern what it says. Now continue piece at the end of row where ball is (bottom of front piece). Cast on new stitches for band as an extension of the stitches pick up at the bottom of front piece (cast on stitches from wrong side. We cast on 16 stitches, but it can be different from pattern to pattern). Work band over the 16 stitches at the same time as band is knitted together with stitches picked up along the front piece as follows: ROW 1 (= right side): Slip first stitch on to right needle purlwise with strand in front of piece, * knit 1, slip 1 stitch on to right needle purlwise with strand in front of piece *, work from *-* until 1 stitch remains of the 16 band stitches, slip last stitch on to right needle knitwise, with strand behind piece, knit next stitch, pass slipped stitch over stitch worked, turn. ROW 2 (= wrong side): * Slip first/next stitch on to right needle purlwise with strand in front of piece, knit 1 *, work from *-* over all the 16 band stitches, turn. Repeat rows 1 and 2. Read in the pattern you are working from when buttonholes should be knitted. Work buttonhole, begin from right side, as follows: Work the first 8 stitches as before, turn and work over the 8 stitches as before, work 3 rows in total over the 8 stitches (work last row from right side). Cut the yarn. Work 4 rows in total as before over the remaining 8 band stitches (work first row from right side) and work last stitch from right side together with next stitch along edge of jacket as before. On last row from wrong side work as before over all band stitches and continue as before over all band stitches. We use the yarn DROPS Snow in the video. You must read a pattern to be able to follow this video properly. You’ll find a pattern using this technique by clicking on the pictures below.
Video thumbnail for How to work a double neck edge and bands
15:50
How to work a double neck edge and bands

In this DROPS video we show how to work a double neck edge and bands which are used in the «Love Links» jacket in DROPS 217-18. We have already worked 9 cm = 3 1/2" to the neck edge. On row 1 we show how to bind off 6 stitches (= band), knit over the next stitches and increase at the same time new stitches evenly over these stitches. Work rib over the last 6 stitches + 1 edge stitch in garter stitch. On row 2 we show how to bind off 6 stitches (= band), purl over the next stitches, purl yarn over twisted = no holes. Work 1 edge st in garter st in each side. Then work the yoke, read a pattern for further information about increases, marker and charts. Then knit up stitches along the bands, remember buttonholes. Then sew band to neck edge inside 1 edge stitch with seam in towards wrong side of garment. Fold rib at the top of neck double in towards wrong side of garment. Sew together opening mid front with small stitches. The jacket in DROPS 217-18 is worked in DROPS Merino Extra Fine, but in the video we use a thicker yarn; DROPS Snow. You must read a pattern to be able to follow this video properly. You’ll find a pattern using this technique by clicking on the picture below.
Video thumbnail for How to work a loose part of a jacket band separately.
14:46
How to work a loose part of a jacket band separately.

In this DROPS video we show how to work a loose part of a jacket band separately, and then sew it on the front piece afterwards. We have already worked the neck in rib with a buttonhole and 5 garter stitches in each side. These band stitches are worked in GARTERS and put on a stitch holder. Cast on a new stitch on each side, which will later be bind off = edge stitch which is worked in garter stitch. Work the back piece in stockinette stitches and increase according to pattern. Then work the loose bands to the correct size before putting them together with the yoke, then also bind off the edge stitches. Remember to bind off for buttonholes. Sew the bands neatly inside the 1 edge stitch on the yoke. We use the yarn DROPS Snow in the video. A band like this is used in the «Scent of pine Jacket» in DROPS 215-7, you can find the pattern by clicking on the picture below.