DROPS Children 49 · Lots of new kid designs!

How to work saddle shoulders with pouffe sleeves - back and forth

In this DROPS video we show how we work the beginning to the saddle shoulders with pouffe sleeves, working back and forth, like it is worked in the “White Water Jacket” in DROPS 222-26. The same technique is used in the "White Water" sweater in DROPS 222-25 - even if beginning of the piece is first worked in the round. We use the stitch numbers in the smallest size and we have already worked the neck edge (3 cm = 1 1/8"). We start the video by showing which stitches are set on a thread (front pieces and back piece). The saddle shoulders are worked separately. Read in the pattern under SADDLE SHOULDERS how it is worked. This jacket is worked in 2 threads DROPS Kid Silk but in the video, we use 1 thread DROPS Air. You must read the pattern to be able to follow this video properly. You’ll find the pattern by clicking on the picture below.

Patterns using this technique

DROPS 222-26

DROPS 222-26
DROPS 222-25

DROPS 222-25
Change language:

Video #1667, listed in: Learn to knit, Knitting Yoke Techniques, Saddle shoulder

Our videos do not have sound. We are a worldwide company and our videos are watched by people speaking endless of different languages and many do not understand English. So since there is not a given language for us to use, we instead have written instructions to accompany the video, and then there is no sound to disturb while watching.

You can adjust the speed of this video by clicking on the icon, on the play bar.

Country flag Reintje Van Bentum wrote:

Moet de halsrand niet eerst in tricotsteek gebreid worden.

03.08.2023 - 17:32

DROPS Design :

Dag Reintje,

Nee, de hals wordt gelijk in boordsteek (A.1 en A.2) gebreid. Zo is dit ook in het patroon aangegeven.

05.08.2023 - 07:33

Country flag Tineke Pols wrote:

Mooi patroon, maar kan ik het filmpje ook bekijken met Nederlandse tekst. Tevens heb ik geen geluid terwijl deze wel aan staat. Ik hoor het graag. Tineke

06.04.2023 - 20:05

Leave a comment or question to this video

Your email address will not be published. Required fields are marked *.

You might also like

Video thumbnail for How to work saddle shoulder increase back and forth
9:45
How to work saddle shoulder increase back and forth

In this DROPS video we show how to work saddle shoulder increase back and forth, both from right side and wrong side. We have put 4 markers in the piece and it increases like this: BEFORE MARKER (applies from right side): The stitch is twisted towards the right. Use left needle to pick up thread between 2 stitches from row below, pick up thread from behind and knit stitch in front loop. AFTER MARKER: The stitch is twisted towards the left. Use left needle to pick up thread between 2 stitches from row below, pick up thread from front and knit stitch in back loop. BEFORE MARKER (applies from wrong side): The stitch is twisted towards the right. Use left needle to pick up thread between 2 stitches from row below, pick up thread from front and purl stitch in back loop. AFTER MARKER: The stitch is twisted towards the left. Use left needle to pick up thread between 2 stitches from row below, pick up thread from behind and purl stitch in front loop. We use the yarn DROPS Snow in the video. You must read a pattern and if necessary, look at the charts to be able to follow this video properly. You’ll find a pattern using this technique by clicking on one of the pictures below.
Video thumbnail for How to work a body with English rib together again
11:46
How to work a body with English rib together again

In this DROPS video we show how we work a body together again in English rib after binding off stitches for sleeve opening, as it is done in the Mountain Moraine vest in DROPS 210-4. We have a fewer number of stitches than what is written in the pattern. Work front piece according to chart A1a, (work garter stitches now as 1st stitch in A.1a), cast on new stitches under 1st sleeve, work back piece after the same chart (A.1a), cast on new stitches under 2nd sleeve / at the end of the round. Now work A.1a in the round over all the stitches. On the first round work the 3 cast-on stitches under each sleeve without yarn overs. This vest is worked in DROPS Air, but in the video we use a thicker yarn; DROPS Snow. You must read the pattern and look at the charts to be able to follow this video properly. You’ll find the pattern by clicking on the pictures below and other relevant videos.
Video thumbnail for How to divide a piece for front and back pieces and how to bind off shoulder stitches in English rib
8:38
How to divide a piece for front and back pieces and how to bind off shoulder stitches in English rib

In this DROPS video we show how to divide a piece for front and back pieces and how to bind off shoulder stitches, as done in vests in DROPS 210-4 and 217-13. In the Slippery Slopes Sweater in 217-14 we dont bind off the stitches for the sleeve opening, but put the shoulder stitches on a thread. We have fewer stitches than what is written in the patterns. Start in the middle of the back and work the number of stitches written in the pattern, we work 13 stitches in English rib, 1 stitch in garter stitch (K1), then bind off stitches for the 1st sleeve opening (yarn overs are bind off as separate stitches to avoid the bind-off edge being tight). Work English rib over the front piece, 1 garter stitch (K1), bind off to the 2nd sleeve opening, 1 garter stitch(K1) and then work English rib rest of the round. Cut the strand. Allow the other stitches to remain on the needle.Work from RS (the stitches must now be moved to the left side of the needle). Work as follows from RS: 1 garter stitch (K1), A.4 until 1 stitch remains and finish with 1 stitch in garter stitch (K1). Work like this back and forth to the stated size in the pattern (make sure that the last row is from WS). Work the front piece the same as the back piece (the stitches are moved to the left needle). These vests are worked in DROPS Air, but in the video we use a thicker yarn; DROPS Snow. You must read the pattern and look at the charts to be able to follow this video properly. You’ll find patterns by clicking on one of the pictures below and other relevant videos.
Video thumbnail for How to start working a garment in English rib after charts - Part 2
17:11
How to start working a garment in English rib after charts - Part 2

In this DROPS video we show how to continue working after charts A.1, A.2 and A.3 used in the Mountain Moraine vest in DROPS 210-4 and the Easy Over vest in DROPS 217-13. We have already worked chart A.1 once in height and now only A.1a is repeated over A.1 in height. In the video we show how to work round 9. (increase round) and round 10, then we work round 15 (increase round) and round 16. Then we work A.2a over A.2 and A.3a over A.3 (we show the first round of A.2a and A.3a). When all the increases are finished (read the pattern for the number of increases), work A.1a over all stitches until the work has the correct measurements (read the pattern for measurements). Adjust so the next round is purled. These vests are worked in DROPS Air, but in the video we use a thicker yarn; DROPS Snow. You must read the pattern and look at the charts to be able to follow this video properly. You’ll find patterns by clicking on one of the pictures below and other relevant videos.
Video thumbnail for How to increase for the yoke for a garment with a saddle shoulder
5:50
How to increase for the yoke for a garment with a saddle shoulder

In this DROPS video we show how to increase for the yoke for a garment with saddle shoulder by increasing 8 stitches on one round. This technique is used in the "Country Muse" sweater in DROPS 216-40 and the "Country Muse Cardigan" jacket in DROPS 216-39. We have already worked a neckline, increases for saddle shoulders and sleeve and start the video by moving sleeve markers to the stitches where increase for the yoke should be. Increase like this: Start before the marker-stitch, use left needle to pick up strand between 2 stitches from the row below, pick up strand from behind and knit stitch in front loop, work marker-stitch in stocking stitch as before, use left needle to pick up strand between 2 stitches from the row below, pick up strand from the front and knit stitch in back loop (= 1 stitch increased on each side of the marker-stitch). The sweater in DROPS 216-40 and the jacket in DROPS 216-39 are worked in DROPS Lima, but in the video we use a thicker yarn; DROPS Snow. You must read a pattern to be able to follow this video properly. You’ll find a pattern using this technique by clicking on one of the pictures below.
Video thumbnail for How to increase to sleeve to a garment with saddle shoulder
9:51
How to increase to sleeve to a garment with saddle shoulder

In this DROPS video we show how to increase to sleeves to a garment with saddle shoulder by increasing 2 stitches on each sleeve. This technique is used in the "Country Muse" sweater in DROPS 216-40 and the "Country Muse Cardigan" jacket in DROPS 216-39. We have already worked a neckline and increases for saddle shoulders for a sweater and start the video by moving saddle shoulders markers to where the sleeves are increases. Increase like this before 1st and 3rd makers: Use left needle to pick up strand between 2 stitches from the row below, pick up strand from behind and knit stitch in front loop (= 1 stitch increased). Increase like this after 2nd and 4th makers: Use left needle to pick up strand between 2 stitches from the row below, pick up strand from the front and knit stitch in back loop (= 1 stitch increased). Knit next round, but if it is a sweater purl from WS. Remember there are only increases for the sleeves, the number of front piece and back piece remains the same. The sweater in DROPS 216-40 and the jacket in DROPS 216-39 are worked in DROPS Lima, but in the video we use a thicker yarn; DROPS Snow. You must read a pattern to be able to follow this video properly. You’ll find a pattern using this technique by clicking on one of the pictures below.