Helmet hat – worked sideways

In this DROPS video we show how to work the baby hat in DROPS Baby 14-16. In the pattern the hat is knitted in DROPS Alpaca from Garnstudio, but we use a thicker yarn in the video, DROPS Snow for Garnstudio. We don’t cast on the sts no as it says in the pattern, but we have the cm measurements for the smallest size (1/3 months). REMEMBER - you will also need to read the pattern to be able to follow. To see the pattern, go to:
DROPS BABY 14-16

To see a video on how to sew this pointed hat together, go to:
Assembly devil/helmet hat
Change language:

Video #1058, listed in: Knitting Videos, Pattern tutorials, Baby & Children, Knitting pattern tutorials

Our videos do not have sound. We are a worldwide company and our videos are watched by people speaking endless of different languages and many do not understand English. So since there is not a given language for us to use, we instead have written instructions to accompany the video, and then there is no sound to disturb while watching.

You can adjust the speed of this video by clicking on the icon, on the play bar.

Rebecca wrote:

Hej! Jag tycker att mössan blir extra fin med Drops snow som ni använder i videon - finns det någon stickbeskrivning som utgår från Drops snow istället för Drops alpaca? Jag antar att man lägger upp färre maskor med Snow tex?

05.09.2024 - 11:11

DROPS Design :

Hei Rebecca. Du kan evnt regne om ved å bruke den oppgitte strikkefastheten. Eller ta en titt på baby luen i DROPS Baby 16-12. Ikke helt den samme oppskriften, men den er skrevet og strikket i DROPS Snow. mvh DROPS Design

09.09.2024 - 07:52

Päivi wrote:

Mitä videolle on tapahtunut äänen osalta, ei kuulu lainkaan ääntä.

23.09.2023 - 10:48

DROPS Design :

Hei, kaikki videomme ovat äänettömiä.

18.10.2023 - 16:28

Bettina wrote:

Lyd virker vist ikke? Har prøvet fra flere devices?

27.02.2023 - 20:25

Anneli Blomberg wrote:

Tack för den fina videon som visade hur jag ska sticka mössan. Stor hjälp till mig som inte stickat på 25 år.

15.11.2022 - 20:18

Eva Hammarén wrote:

Om man minskar på vartannat varv o ökar vart 4e så minskar maskorna hela tiden. Hur ska ja bära mig åt?

14.03.2021 - 11:54

DROPS Design :

Hei Eva. Ta en titt på denne Lession, det er en step-by-step leksjon som viser hvordan luen blir, med forklaring og bilder: Hur man stickar en hjälm-mössa mvh DROPS design

15.03.2021 - 08:11

Mitzi Carlsen wrote:

Findes der en video, hvor man kan se, hvordan huen syes sammen ?

25.02.2021 - 19:29

DROPS Design :

Hei Mitzi. Ja, under denne videoen er det en video som viser hvordan sy sammen en slik lue: "Hvordan syes djævlehuen sammen?" mvh DROPS design

03.03.2021 - 11:46

Ulla Sandbeck wrote:

Jeg har strikket efter opskriften, og det blev til en kyse, hvor er opskriften til djævelhue

22.07.2020 - 07:48

Lena Ytterdahl wrote:

Hej ! vad som menas med Fortsätt att öka med 1 maska på högersida på vart fjärde varv och minska med i 1 maska vartannatvarv på vänster sida.Ska jag sticka som tidigare. men ändra till att öka på höger sida vart 4 ;varv och minska på vänster sida vartannat varv på rätsidan (samma varv ? Eller ska jag sticka 4 varv vanligt utan ökningar och minskningar och sen på 4 varvet börja öka och minska .

06.01.2020 - 18:35

Lise Høgh wrote:

Har i en let opskrift på retstrikket djævle hjelm i et langt stykke og i ren bomuld til for tidlig fødte babyer❣️ På forhånd tak

03.11.2019 - 23:28

DROPS Design :

Hei Lise. Vi har mange djævel luer i rettstrikk. Bruk vår søkemotor og skriv inn djævellue og velg baby. Inne på hver oppskrift er det en garnkalkulator du kan bruke og da får du opp garnalternativer. F.eks kan du velge Safran istedenfor Alpaca. Bare husk å sjekke at strikkefastheten din stemmer med det som står i oppskriften. God Fornøyelse!

04.11.2019 - 09:54

Elsebet wrote:

Hvordan strikkes 2. Og 4. Pind (vrangsiden)?

10.10.2019 - 21:15

DROPS Design :

Hei Elsebet. I oppskriften står det: 2.p (= vrangen): Strik ret (omslaget strikkes drejet ret, dvs strik i bagerste del af m i stedet for forreste del af m). Se video fra tiden 02:51 til 03:14. 4.pinne strikkes lik. Du kan også se vår Step-by-Step Leksjon på denne luen under Tips&Hjælp / DROPS Lektioner / Hvordan strikker man djævlehuen Aviator hat. God Fornøyelse!

14.10.2019 - 09:23

Leave a comment or question to this video

Your email address will not be published. Required fields are marked *.

You might also like

7:40
Assembly devil/helmet hat

This is how you sew this pointed hat together. Back of hat = bind off row, i.e. 2 whole points and 2 half points. Sew hat tog, edge to edge along bind off row as follows: Sew first half point to one side of the first whole point. Sew the other side of first whole point to one side of second whole point. Then the other side of second whole point to the last half point. At last sew hat tog mid back.
15:52
How to work the slippers in DROPS Children 27-19

In this DROPS video we show to work the “Lemon Jelly” slippers in DROPS Children 27-19. By working with smaller needles than you normally do for DROPS Snow, you get a firmer slipper. But remember the needle size in the pattern are only the recommended size. We use needle 4 in the video and working according to size 20/21 (the smallest size). We have already cast on 24 stitches and show a bit of the 1st round which is knit and a bit of the 2nd round which is purled (= 1 RIGDE in garter stitch). Work garter stich until the piece measures 3 cm = 1 1/8". Then the first 8 stitches of the round are kept on the needle and the remaining 16 stitches are put on 1 thread. Cast on 1 stitch at the beginning and 1 stitch at the end of the 8 stitches on the needle. Work garter stich back and forth until the work measures 4 from where the stitches were put on 1 thread. Bind off 1 stitch in each side. Knit up 6 stitches in each side and put the stitches on the thread back on the needle. Put 1 marking thread in the middle of the front and 1 in the middle of the back. When the piece measures 2 from the marker threads, decrease 1 stitch on each side of the marker threads, decrease like this every other round until the piece measures 4 cm = 1 1/2". Then bind off the remaining stitches and sew the seam under the foot in outer loops of edge stitch. These slippers are worked in DROPS Snow, the same yarn we use in the video. You must read the pattern to be able to follow this video properly. You’ll find the pattern by clicking on the picture below.
27:18
How to decrease and increase to the hat in DROPS Baby 21-34

In this DROPS video we show how to increase and decrease by the stitch markers. We use a smaller number of stitches / rows than what is written in the pattern and we have already worked the first rows and put 7 stitch markers in the hat. The first and last stitch is knitted, both from RS and from WS. We start by showing how to increase stitches at 1st, 3rd, 5th and 7th mark and how to decrease 1 stitch on each side of stitch with marker at 2nd, 4th and 6th mark from RS. Then we show how to work the YO twisted from WS to avoid holes. Then we show 1 row from RS again, with inc and dec. When all inc have been worked, work rows with only dec (at markers 2, 4 and 6) until there are 15 stitches left. Work next row from RS as follows: K 1, K 2 tog, K 9, K 2 tog, K 1 = 13 sts. Repeat dec in each side on every row (from WS P the 2 sts before and after edge st tog) until 5 sts remain. On the last row from WS work 1 edge st, P 3 sts tog and work 1 edge st. Pull thread through the remaining stitch. Sew the hat together mid back inside 1 edge stitch. TIES: Cast on 4 stitches. Work as follows: * K 1, place yarn in front of piece (towards you), slip 1 st as if to P, place yarn behind piece (from you) *, repeat from *-* on more time and on all rows. Work to desired length and bind off. Sew the ribbon at the bottom of one tip on ear flap. This hat is worked in DROPS Alpaca, but in the video we work with a thicker yarn; DROPS Snow. You must read the pattern to be able to follow this video properly. You’ll find the pattern by clicking on the picture below.
8:13
How to begin working the baby body in DROPS Baby 31-6

In this DROPS video we show how to start working the “Celestina” baby body in DROPS Baby 31-6. Work 4 parts of chart A.1, and then put 2 parts together and work after chart to A.2. This baby body is worked in DROPS Baby Merino, but in the video, we work with a thicker yarn; DROPS Snow. You must read the pattern and look at the charts to be able to follow this video properly. You’ll find the pattern by clicking on the picture below.
13:58
How to work after chart to the baby mittens in DROPS Baby 36-10

In this DROPS video we show how to work after chart A.1 to the baby mittens “Tiny Mitts” in DROPS Baby 36-10. We work the smallest size and have already worked a rib and start the video by showing the four first round to the chart, we show the beginning and end of each round. Then we show the first decrease, both sides of the markers and then we show how to knit 2 and 2 stitches together when it is 8 stitches left. These mittens are worked in DROPS Baby Merino, but in the video, we work with a thicker yarn; DROPS Snow. You must read the pattern and look at the chart to be able to follow this video properly. You’ll find the pattern by clicking on the picture below.
How to work the decreases in DROPS Baby 33-36

In this DROPS video we show how to decrease after chart to the “New Chick” hat in DROPS Baby 33-66. We work 4 rapports of the chart and have already worked twice in the high. Decrease as follows: Slip stitch / YO before stitch with marker, knit stitch with marker + the next stitch together, pass the slipped stitch over (= 2 stitches decreased). Repeat this decrease on all repetitions at the 3 arrows. This hat is worked in DROPS BabyMerino, but in the video we work with a thicker yarn; DROPS Snow. You must read the pattern and look at the chart to be able to follow this video properly. You’ll find the pattern by clicking on the picture below.