Birte escribió:
Hallo! Muss ich bei der Ferse nach der 4. Reihe so weiter stricken, wie in der 4 oder wieder mit der 1. Reihe anfangen?
05.01.2015 - 19:52DROPS Design respondió:
Weder noch - Sie stricken folgerichtig weiter, d.h. Sie heben in der 5. R 1 M wie zum Rechtsstr ab, ziehen den Faden an und stricken, bis noch 3 M übrig sind, dann wenden Sie. In der 6. R 1 M wie zum Linksstr abheben, den Faden anziehen, stricken bis noch 3 M übrig sind, wenden. 7. R: 1 M wie zum Rechtsstr abh, Faden anziehen, stricken bis noch 4 M übrig sind usw. Wenn noch 18 M auf der Nadel sind, stricken Sie umgekehrt, d.h. immer 1 M mehr.
11.01.2015 - 16:10
Carina escribió:
Jeg forstår ikke helt det med at lave udtagningen efter 18 m i hælen, da mønsteret jo faktisk går op selv hvis man undlader denne udtagning... Eller er der noget jeg ikke forstår?
14.12.2014 - 14:38DROPS Design respondió:
Hej Carina. Du skal lave udtagningen igen for at faa den hael som er meningen paa denne sok.
18.12.2014 - 16:26
Lori escribió:
Please indicate which type heel this is. I am not able to follow the directions as stated. Thank you
14.10.2014 - 02:18DROPS Design respondió:
Dear Lori, this is here a heel knitted in diagonal, the video below shows how to work this heel. Happy knitting!
14.10.2014 - 09:32
Barb escribió:
Thanks for the quick response, I'm afraid I didn't state the problem well. At the start of the heel doing one row of wine then one row of white A. leaves the yarns at the opposite ends of where they need to be for the next time you need them and B.the first row of wine makes a break in the line ...should the first st. of the heel not be white for continuity? I find it just does not work well. I have spent over 20 hours on trying to get this heel to work.....please help.
01.10.2014 - 14:43DROPS Design respondió:
Dear Barb, before starting heel you have to cut the strands and then work diagonal heel over 1st and 4th needle starting with 1 row red, 1 row off-white - see below. If you rather want to have a off-white st on this place, you may work it or embroider it with duplicate sts. Happy knitting!
01.10.2014 - 15:23
Barb escribió:
Why can I not get the lines on the heel to match up with A3 pattern when I go back to knitting in the round after the heel is completed.
27.09.2014 - 20:16DROPS Design respondió:
Dear Barb, heel should be worked as follows : 1 st red, 1 st off-white, repeat A.3 a total of 6 times increasing 1 st after the first 18 sts (= you will work A.3 6 times + 1st st in A.3 to get both sides the same), 1 st off white, 1 st red (= 41 sts). Happy knitting!
29.09.2014 - 09:27
Susan Burns escribió:
We are using this pattern in my knitting group to make Christmas stocking, but we are having trouble understanding and following the heel instruction's. I have now decided to knit this part separate and I have worked the first four rows. When it says continue until you have 18sts remain in the middle of needle, I don't understand what to so to achieve this? Do I continue knitting less stitches so the next row would be 3sts remain? Thanks
13.08.2014 - 16:15DROPS Design respondió:
Dear Mrs Burns, this pattern uses the technique of the diagonal heel, it is worked as shown in the video below. Happy knitting!
14.08.2014 - 12:30
Elisabeth escribió:
Er oppskriften feil? Burde ikke A-3 være rød bakgrunn med hvite linjer, slik bildet er? Mønsteret sier motsatt.
17.12.2013 - 22:31DROPS Design respondió:
Hei Elisabeth. Det har du ret i. Vi skal faa det rettet. Tak for meldingen.
18.12.2013 - 10:26
Wil Van De Steeg escribió:
Super leuk :-)
02.12.2013 - 14:01Bettina Martinez escribió:
Beautiful, I like it!!!
01.12.2013 - 17:38
Hélène Et Mahélia escribió:
Un nom ? OK : la chaussette KARISMA-GIC !! :)
01.12.2013 - 10:59
Mr. Kringle's Stocking |
|||||||
|
|||||||
Navidad DROPS: Media de Navidad tejida con patrón de jacquard noruego, en “Karisma”.
DROPS Extra 0-986 |
|||||||
PATRÓN: Ver diagramas A-1 a A-3. El patrón es tejido en pt jersey. TALÓN: Tejido de ida y vuelta en pt jersey. HILERA 1 (= LD): Tejer hasta que reste 1 pt, virar la pieza. HILERA 2 (= LR): Deslizar el primer pt de revés, apretar el hilo y tejer hasta que reste 1 pt, virar la pieza. HILERA 3 (= LD): Deslizar el primer pt de derecho, apretar el hilo y tejer hasta que resten 2 pts, virar la pieza. HILERA 4 (= LR): Deslizar el primer pt de revés, apretar el hilo y tejer hasta que resten 2 pts, virar la pieza. Continuar de esta manera hasta que resten 18 pts en el centro en la ag. Continuar de ida y vuelta, pero ahora tejer 1 pt más por cada hilera encima del talón. Para evitar que se formen agujeros en las transiciones, levantar el hilo antes del pt a ser tejido y deslizarlo retorcido en la ag. Tejer este hilo junto con el pt. Tejer de esta manera hasta haber tejido todos los pts del talón. TIP PARA DISMINUCIÓN: Dism de la manera sig 3 pts antes del marcapuntos: Tejer 2 pjd, 1d. Dism de la manera sig después del marcapuntos: 1d, deslizar 1 pt de derecho, 1d, pasar el pt desl por encima. ------------------------------------------------------ MEDIA DE NAVIDAD: Tejida en redondo en la ag. Mon 80 pts en ag circular tamaño 2.5 mm con rojo vino. Tejer en pt jersey por 3 cm. Cambiar a las ag de doble punta tamaño 3.5 mm, tejer 1 vta de la manera sig: Tejer 2 pjd, 1 HEB (lazada). Tejer 3 vtas de derecho. Distribuir los pts para tener 20 pts en cada una de las 4 ag de doble punta. Tejer A-1, después continuar con A-2. RECUERDE MANTENER LA MISMA TENSIÓN DE TEJIDO DE LA MUESTRA! Después de haber tejido A-2 3 veces en total verticalmente (la pieza mide aprox 29 cm), cortar los hilos. Ahora tejer el talón sobre los pts de la 1ª y de la 4ª ag (= 40 pts), deslizar los otros 40 pts (= empeine) a 1 gancho o seguro aux. Empezar por el LD, tejer 1 hilera con rojo vino y 1 hilera con blanco hueso sobre los 40 pts del talón. AL MISMO TIEMPO, tejer el TALÓN – ver explicación arriba. Continuar en pt jersey de ida y vuelta con rojo vino y, AL MISMO TIEMPO, tejer el talón. Tejer hasta que resten 2 hileras en el talón. Después tejer 1 hilera con blanco hueso y 1 hilera con rojo vino. Después deslizar los 40 pts del gancho o seguro aux nuevamente a la ag y tejer en redondo sobre todos los 80 pts con rojo vino de la manera sig (empezar la vta en la 2ª ag, es decir, después del talón): Tejer A-2 como antes sobre los 40 pts del centro del empeine, tejer 1 pt rojo vino, 1 pt blanco hueso, tejer A-3 (= 6 pts) sobre los 36 pts sig y, AL MISMO TIEMPO, aum 1 pt (después de los primeros 18 pts) para que el patrón empiece y termine de la misma manera en cada lado y, terminar con 1 pt blanco hueso y 1 pt rojo vino. Tejer el diagrama A-2 2 veces verticalmente después del talón y terminar con la penúltima hilera de A-2. (faltan aún aprox 4.5 cm para las medidas finales). Insertar 1 marcapuntos en cada lado para tener 40 pts en la parte de arriba del pie y 41 pts en la planta del pie. Continuar con 1 vta rojo vino y 1 vta blanco hueso, después tejer en pt jersey con rojo vino. AL MISMO TIEMPO, dism para los dedos en cada lado de cada marcapuntos de la manera sig – LEER TIP PARA DISMINUCIÓN: Dism a cada 2 vtas un total de 6 veces, después en cada vta un total de 4 veces. Colocar la media en posición horizontal y usando la técnica de remallado/costura invisible, coser los pts del lado superior de los dedos con los pts del lado inferior. Cortar y asegurar el hilo. Doblar la orilla superior hacia adentro, coser con pequeños puntos en el interior, sin apretar demasiado. Pasar un listón de seda arriba, en la parte de atrás de la media, este es usado para colgar la media. |
|||||||
Explicaciones del diagrama |
|||||||
|
|||||||
![]() |
|||||||
¿Terminaste este patrón?Entonces, etiqueta tus fotos con #dropspattern o envíalas a la galería #dropsfan. ¿Necesitas ayuda con este patrón?Encontrarás 21 videos tutoriales, un espacio para comentarios/preguntas y más visitando la página del patrón en garnstudio.com © 1982-2025 DROPS Design A/S. Todos los derechos reservados. Este documento, incluyendo todas sus sub-secciones, está protegido por los derechos de autor (copyright). Lee más acerca de lo que puedes hacer con nuestros patrones en la parte de abajo de cada patrón de nuestro sitio. |
Escribe un comentario sobre DROPS Extra 0-986
¡Nos encantaría saber qué piensas acerca de este patrón!
Si quieres escribir una pregunta referente al patrón, por favor asegúrate de elegir la categoría correcta en el formulario debajo, para acelerar el proceso de respuesta. Los campos obligatorios están marcados con un *.