DROPS / 152 / 4

French Riviera by DROPS Design

Knitted DROPS shawl with lace pattern in ”Lace”.

Tags: lace, shawls, top down,

DROPS design: Pattern no la-018
Yarn group A
Size: approx. 50 cm measured at the back of neck and down mid back.

DROPS LACE from Garnstudio
100 g colour no 6410, turquoise

DROPS CIRCULAR NEEDLE (80 cm) SIZE 3.5 mm – NOTE! Read about knitting tension below.

Want to use a different yarn? Try our yarn converter!
Not sure which size you should choose? Then it might help you to know that the model in the picture is approx. 170 cm and uses size S or M. If you are making a jumper, cardigan, dress or similar garment, you will find a graphic with the measurements of the finished garment (in cm) at the bottom of the pattern.
Comments (96)

70% Alpaca, 30% Silk
from 4.30 £ /50g
DROPS Lace uni colour DROPS Lace uni colour 4.30 £ /50g
Wool Warehouse Direct Ltd
DROPS Lace mix DROPS Lace mix 4.30 £ /50g
Wool Warehouse Direct Ltd
DROPS Needles & Hooks
You can get the yarn to make this pattern from 8.60£. Read more.

Pattern instructions

NOTE: This pattern is written in British English. All measurements in charts are in cm. For conversion from cm to inches - click here. There are different terms for crocheting in British and American English. If this pattern includes crochet, click for "crochet terms" here. For this pattern in American English, please click here.
This garment is to be soaked and blocked/stretched to size afterwards so the knitting tension is not that important. But to get a sense of whether you are working too loose/tight, work a test on needle size 3.5 mm in stocking st and get approx. 23 sts x 30 rows = 10 x 10 cm.

GARTER ST (back and forth on needle):
K all rows. 1 ridge = 2 rows K.

See diagrams A.1 to A.6. The diagrams show all rows in pattern seen from RS.

Inc with YO, YO should not be twisted on next row but should make a hole in the piece.

Worked back and forth on circular needle. Cast on 63 sts on circular needle size 3.5 mm with Lace, insert 2 markers in the piece on each side of the middle 57 sts. Continue in stocking st with 1 edge st in GARTER ST - READ EXPLANATION ABOVE in each side of piece - AT THE SAME TIME inc as follows - READ INCREASE TIP ABOVE:
Inc 1 st in each side inside 1 edge st on every row and inc 1 st on each side of the middle 57 sts every other row. REMEMBER THE KNITTING TENSION! Continue like this until inc have been done 46 times in total on each side of the 57 sts and 92 times in each side = 339 sts on needle.
NOTE! Adjust so that last row is from RS. On next row from WS inc 1 st inside edge st in each side = 341 sts.
Piece now measures approx. 30 cm mid back.
Then work PATTERN - READ EXPLANATION ABOVE! according to diagrams A.1 to A.3, beg from RS as follows: Work 1 edge st in garter st, A.1 (= 6 sts), A.2 until 4 sts remain on needle, then work diagram A.3 and finish with 1 edge st in garter st. Work diagram 4 times vertically in total. Then work diagrams A.4 to A.6 the same way. After last row in diagram P 1 row from WS before loosely casting off with K from RS. Cast off with a YO for every YO from last row in diagram to make the edge extra elastic and easy to stretch and shape. Piece measures approx. 50 cm vertically.

Place the shawl in lukewarm water until it is soaking wet. Carefully squeeze out the water from the shawl - do not twist. Then roll the shawl in a towel and squeeze to remove more water - the piece will now only be moist. Place the shawl on a carpet or mattress - carefully stretch it out to measurements. On this shawl tips can be made in the bottom edge by stretching a little extra where 2 K sts are (diagram A.5). Also stretch the edge st in each side at the bottom of edge, fasten pins in each tip and along the other edges. Leave shawl to dry. Repeat the process when the garment has been washed.

This pattern has been corrected. .

Under Shawl: additional sentence in the middle of text: … NOTE! Adjust so that last row is from RS. On next row from WS inc 1 st inside edge st in each side = 341 sts. + New diagram
A.1 (row 2.& 6.) and A.3 (row 6.,8. & 10.)
Updated online: 09.05.2014


= K from RS, P from WS
= 1 yo between 2 sts
= K2 tog
= slip 1 as if to K, K1, psso
= slip 1 as if to K, K1, psso, K2 tog
= slip 1 as if to K, K2 tog, psso

Comments (96)

Leave your comment!

Diane 24.02.2018 - 22:11:

Je cherche le patron écris au lieu du diagramme. Est-ce disponible?

DROPS Design 26.02.2018 kl. 09:00:

Bonjour Diane, nous n'avons que des diagrammes pour ce modèle, lisez les diagrammes en commençant en bas à droite, de droite à gauche sur l'endroit et de gauche à droite sur l'envers, vous trouverez la légende des diagrammes juste au-dessus. Bon tricot!

Christine 05.09.2017 - 05:03:

Merci+++++pour la vidéo qui explique comment rabattre en ajoutant un jeté! Si je comprends bien, on ne fait pas ces jetés à chaque maille rabattue mais seulement sur les mailles vis à vis les jetés du dernier rang du motif n'est ce pas?

DROPS Design 05.09.2017 kl. 08:47:

Bonjour Christine, faites 1 jeté avant chaque jeté du dernier rang du diagramme, et rabattez-le comme une maille normale (comme montré dans la vidéo). Bon tricot!

Christine 05.09.2017 - 04:59:

Merci+++++pour la vidéo qui explique comment rabattre en ajoutant un jeté! Si je comprends bien, on ne fait pas ces jetés à chaque maille rabattue mais seulement sur les mailles vis à vis les jetés du dernier rang du motif n'est ce pas?

Lelletta 17.03.2017 - 00:09:

Grazie! sempre gentili e rapidi nelle risposte!!

Lelletta 16.03.2017 - 19:20:

Buonasera! Vorrei eseguire questo scialle con safran o cotton viscose perchè mi serve fresco ed elegante. quale mi consigliate?Devo comprare la stessa quantità?

DROPS Design 16.03.2017 kl. 19:34:

Buonasera Lelletta. Può usare il filato che preferisce. Cotton Viscose è un filato lucido. Le ricordiamo anche che Lace è comunque un filato molto leggero, adatto anche per scialli estivi. Per calcolare la quantità di filato necessario quando si lavora con un filato diverso, può fare riferimento alla seguente: pagina. Buon lavoro!

Eli 09.01.2017 - 17:18:

Without Russian language????why? MAny peple can't understand .I can't read so difficult texts

DROPS Design 10.01.2017 kl. 09:59:

Dear Eli, for any further assistance, you are welcome to contact your DROPS Store in Russia, see here. Happy knitting!

Marjan 08.01.2017 - 16:28:

Welk model heeft deze sjaal? Wordt het een halve cirkel? Of een halve maan? Of misschien anders? Dank alvast voor uw reactie!

DROPS Design 09.01.2017 kl. 14:44:

Hoi Marjan. Dit is een halve cirkel sjaal

Erika 22.07.2016 - 19:16:

Ich habe dieses Tuch nachgestrickt, in der letzten Musterreihe von A4 bis A6 sind im Diagramm 2 Umschläge zuviel, oder soll das so sein,da es die letzte Mustersatzreihe ist?

DROPS Design 26.07.2016 kl. 13:44:

Liebe Erika, ja das ist so gedacht.

Moreau 07.07.2016 - 18:48:

Bonjour,j'aimerai vous demander si je peux utiliser des aiguilles droites car je ne suis pas très "douée " avec des aiguilles rondes et aussi pour les augmentations de chaque côté pour la lisière,faut-il augmenter tous les rangs donc,endroit et envers.Merci pour votre réponse.AMoreau

DROPS Design 08.07.2016 kl. 10:24:

Bonjour Mme Moreau, on utilise ici des aiguilles circulaires pour avoir suffisamment de place pour y loger toutes les mailles, vous pouvez donc utiliser des droites, mais pensez à bien conserver la bonne tension, même quand il y aura beaucoup de mailles sur vos aiguilles. Quand on augmente tous les rangs, c'est sur l'endroit et sur l'envers, quand on augmente tous les 2 rangs, c'est uniquement sur l'endroit. Bon tricot!

Elise Ertlen 09.06.2016 - 21:50:

Faut il faire une maille lisière en début et fin de rang pour tous les rangs endroit de dentelle ?

DROPS Design 10.06.2016 kl. 08:55:

Bonjour Mme Ertlen, on tricote les diagrammes avec 1 m lis au point mousse de chaque côté (= 1 m tricotée à l'end tous les rangs au début et à la fin de chaque rang). Bon tricot!

Post a comment to pattern DROPS 152-4

We would love to hear what you have to say about this pattern!

If you want to leave a question, please make sure you select the correct category in the form below, to speed up the answering process.

Your email address will not be published. Required fields are marked *.