DROPS / 98 / 20

Lavender Muse by DROPS Design

DROPS Hair band and scarf in Eskimo

Hair band:
Size: one-size

Materials: DROPS Eskimo from Garnstudio
100 g colour no 41, Blue lilac mix

DROPS double pointed needles size 9 mm or size needed to obtain the correct knitting tension.

Measures: approx 29 x 150 cm

Materials: DROPS Alpaca from Garnstudio
100 g colour no 6347, grey lilac
and use: DROPS Vivaldi from Garnstudio
100g colour no 24, Light lilac

DROPS circular needle needles size 7 mm or size needed to obtain the correct knitting tension.

Not sure which size you should choose? Then it might help you to know that the model in the picture is approx. 170 cm and uses size S or M. If you are making a jumper, cardigan, dress or similar garment, you will find a graphic with the measurements of the finished garment (in cm) at the bottom of the pattern.

(Continue to pattern...)

Yarn type
Deals from
DROPS Alpaca Party! / 30% OFF!
2.90 GBP
2.05 GBP
DROPS Alpaca Party! / 30% OFF!
3.05 GBP
2.15 GBP

Tips & Help

Thank you for choosing DROPS Design!

We do our best to make our patterns easy to follow.

For that purpose, each of our patterns has specific tutorial videos to help you, which you will find at the bottom of the page.

We have also step-by-step lessons to help you understand some of the techniques we use in our patterns. You'll find them here!

NOTE: This pattern is written in British English. All measurements in charts are in cm. For conversion from cm to inches - click here. There are different terms for crocheting in British and American English. If this pattern includes crochet, click for "crochet terms" here. For this pattern in American English, please click here.
Knitting Tension: 9.5 sts with 2 threads of Eskimo on needles size 9 mm in garter sts = 10 cm in the width.

Garter sts (back and forth on row): Knit all rows.

Hair band:
Cast on 12 sts on pointed needles size 9 mm with 2 threads of Eskimo. K 4 rows of garter sts. **Knit the next row as follows: 1 edge st in garter sts, *make a yo, K2 tog.*, repeat from *-* and finish with 1 edge st in garter sts. Knit 8 rows of garter sts**, repeat from **-** until the piece measures approx 54 cm(or desired length) – make sure to finish with 4 rows of garter sts after a row of lace holes – and cast off.

Assembly: Sew the short sides tog – sew edge against edge in the most outer part of the most outer sts to avoid the seam becoming chunky.

Knitting Tension: 13 sts with 1 thread of each quality in wave pattern = 10 cm in the width.

Garter sts (back and forth on row): Knit all rows.

Wave Pattern: See diagram M.1 The diagram is shown from the RS. 1st row = RS.

Knitted back and forth length wise. Bend a circular needle size 7 mm double (could use 2 circular needles the same size) and cast on 195 sts on 2 needles ( this is done to make the edge more elastic) with 1 thread of each quality. Remove 1 needle and knit 2 rows of garter sts. Then continue in M.1 with 4 sts of garter sts each side. When the piece measure approx. 28 cm – make sure to finish 1 repeat – knit 2 rows of garter sts before casting off very loosely – knit the first row of M.1 whilst casting off which will make the casting off edge wavy.


= K from the RS, P from the WS
= K from the WS
= make a yo
= K2 tog.

Do you need some help? Here's some tutorial videos that can help you!

For further pattern help, please contact the store where you bought the yarn. Having bought DROPS yarn, you are guaranteed to receive qualified help from a store specializing in the DROPS patterns.

All patterns are carefully reviewed, but we must make reservation for possible mistakes. All patterns are translated from Norwegian and you can always check the original pattern for measurements and calculations.

If you think you have found an error in the pattern, please post your remark or question in our Comments section. Go to original pattern for design DROPS 98-20.