How to work a fan with increases in a stitch

In this DROPS video we show how to work a fan in a stitch and at the same time increases 5 stitches

* Insert needle in stitch with marker thread, make 1 yarn over and pull yarn to the front of piece, knit 1 *, repeat from *-* 5 times in total (= 5 yarn overs on needle). NOTE: Make sure that the yarn overs have the same length (it is important to avoid tight yarn overs to make the knitting tension correct vertically). On next round knit the yarn overs.

You can also decreases fewer / increase more stitches and remember to read the pattern how long the yarn over should be. We use the yarn DROPS Eskimo in the video.

You MUST read the pattern and look at chart, if it is, to be able to follow this video properly. You’ll find a pattern with this fan by clicking on one of the pictures below.

Tags: fan pattern, jumpers, tops,

The video above can be used in the following patterns

Available in:

Leave a comment about this video

Your email address will not be published. Required fields are marked *.