How to knit a textured border

In this DROPS video we show you how to knit the textured border after chart A.1 in DROPS 197-8. We only show the beginning of round 10 and 11.

Round 10: 1 yarn over, * insert the right needle in the middle of the stitch marked with a circle 4 rounds before this round, pick up the strand and pull the loop 3 cm long *, knit 1, repeat from *-* 1 time (= 3 stitches). This we show 3 times.

Round 11: Work yarn over twisted to avoid hole, knit 3 together, knit 1, knit 3 twisted together and purl 1. This we also show 3 times.

Remember the loops that are pulled out must have the correct length so that it does not get too tight.
In this video we use the yarn DROPS Eskimo.

You must read the pattern and look at the diagram to be able to follow this video properly. You’ll find the pattern by clicking on the picture below.

Tags: jumpers, texture,

The video above can be used in the following patterns

Available in:

Leave a comment about this video

Your email address will not be published. Required fields are marked *.