• Free Pattern
Choose your language:

DROPS 87-1 by DROPS Design

DROPS Square Shawl in Vivaldi with Lace Edge

DROPS 87-1

Finished measurements: approx. 125 x 125 cm [49.25" x 49.25"]

200 gr nr 13, beige

DROPS 9 mm [US 13] needles, or size needed to obtain correct gauge.

(Continue to pattern...)

Tips & Help

Learn something new every day!

Not sure of how to get started with this pattern? Under the "Videos" tab at the top of the page you will find a list of how-to videos that can help to get you started - all our patterns have them!

And that's not all - our "Tips & Help" section is filled with lots of resources to get you started with any of our patterns - or with your own designs!

Browse our Video Library to find hundreds of how-to videos and have a closer look of our yarns; or visit our Lessons section for step by step tutorials! "Tips & Help" is also full of pattern inspiration, DROPS fans creations, and so much more! Just take a look here!
NOTE: This pattern is written in American English. All measurements in charts are in inches. For conversion from inches to cm - click here. There are different terms for crocheting in American and British English. If this pattern includes crochet, click for "crochet terms" here. For this pattern in British English, please click here.
Gauge: 11 sts x 22 rows in garter st = 10 x 10 cm.

Lace edge: See chart. The pattern is seen from the right side.

Shawl: Knit the square first in garter st, then knit the lace edge. Cast on 59 sts around 2 needles with Vivaldi (this is to make sure the cast-on edge is elastic). Pull out one needle and knit garter st.
When the piece measures 54 cm (lay piece flat to measure and be sure that the piece measures the same in height as in width). Bind off all sts.

Lace edge: Cast on 36 sts around 2 needles. Pull out one needle and knit Pattern 1. Note that the blank squares in the chart are garter st, not stockinette st.
When Lace edge measures approx. 3.5 meters – adjust to end after a whole repeat – bind off all sts loosely.

Assembly: Fold lace edge in half and put a marker in the fold, fold edge in half again and put markers in the 2 new folds – fold out entire length again.
Pin one end of lace edge to the center of one side of the square, then pin rest of lace edge so that each marker is in the center of one side of the square and the other end meets up with the first end. Pin the lace edge around square but leave approx. 10 cm before and after each corner unpinned. Put a crease in the lace edge at each corner and ease in the excess fabric.
Sew the lace edge to square edge (edge to edge, no seam allowance) and sew the two ends of the lace edge together in the same way.


K from RS, K from WS = garter st
1 yo, K yo on return row
2 yo, on return row K 1 yo and K the other yo into back of loop
bind off 1 st
K 2 tog

Do you need some help?

For further pattern help, please contact the store where you bought the yarn. Having bought DROPS yarn, you are guaranteed to receive qualified help from a store specializing in the DROPS patterns.

All patterns are carefully reviewed, but we must make reservation for possible mistakes. All patterns are translated from Norwegian and you can always check the original pattern for measurements and calculations.

Go to original pattern for design DROPS 87-1. If you think you have found an error in the pattern, please post your remark or question in our Comments section.

DROPS Design