Change language:

DROPS 87-1 by DROPS Design
"Sunset and sand. Happily worn out after a long day... wear a comfortable dress and wrap this one around your shoulders..."
DROPS Square Shawl in Vivaldi with Lace Edge
DROPS 87-1
Finished measurements: approx. 125 x 125 cm [49.25" x 49.25"]

Materials: DROPS VIVALDI
200 gr nr 13, beige

DROPS 9 mm [US 13] needles, or size needed to obtain correct gauge.

(Continue to pattern...)

See deals and shadecard for: DROPS Vivaldi

Comments (15)

Print Pattern Print Photo

The following yarns can be used as alternatives for DROPS Vivaldi. All prices valid per 19/04/2014.

DROPS Tutorial Videos: Bind off with yo

DROPS Tutorial Videos: Bind/cast off from RS

DROPS Tutorial Videos: Cast on with two needles

DROPS Tutorial Videos: Decrease – K2tog (knit 2 together)

DROPS Tutorial Videos: Garter stitch

DROPS Tutorial Videos: Increase – with yo (yarn over)

DROPS Tutorial Videos: Knit (K) - continental

DROPS Tutorial Videos: Knit (K) - US/UK method

DROPS Tutorial Videos: Knit into 2 yo

DROPS Tutorial Videos: Sew together pieces knit in garter

DROPS Tutorial Videos: yo (yarn over)

If you do not find the video you need, click here to go to DROPS Video Index.

Yarn type
  • DROPS VIVALDI UNI COLOUR (50g)
    8.00 USD
NOTE: This pattern is written in American English. All measurements in charts are in cm. For conversion from cm to inch - click here. There are different terms for crocheting in British and American English. If this pattern includes crochet, click for "crochet terms" here. For this pattern in British English, please click here.
Gauge: 11 sts x 22 rows in garter st = 10 x 10 cm.

Lace edge: See chart. The pattern is seen from the right side.

Shawl: Knit the square first in garter st, then knit the lace edge. Cast on 59 sts around 2 needles with Vivaldi (this is to make sure the cast-on edge is elastic). Pull out one needle and knit garter st.
When the piece measures 54 cm (lay piece flat to measure and be sure that the piece measures the same in height as in width). Bind off all sts.

Lace edge: Cast on 36 sts around 2 needles. Pull out one needle and knit Pattern 1. Note that the blank squares in the chart are garter st, not stockinette st.
When Lace edge measures approx. 3.5 meters – adjust to end after a whole repeat – bind off all sts loosely.

Assembly: Fold lace edge in half and put a marker in the fold, fold edge in half again and put markers in the 2 new folds – fold out entire length again.
Pin one end of lace edge to the center of one side of the square, then pin rest of lace edge so that each marker is in the center of one side of the square and the other end meets up with the first end. Pin the lace edge around square but leave approx. 10 cm before and after each corner unpinned. Put a crease in the lace edge at each corner and ease in the excess fabric.
Sew the lace edge to square edge (edge to edge, no seam allowance) and sew the two ends of the lace edge together in the same way.

Diagram

K from RS, K from WS = garter st
1 yo, K yo on return row
2 yo, on return row K 1 yo and K the other yo into back of loop
bind off 1 st
K 2 tog


Do you need some help?

For further pattern help, please contact the store where you bought the yarn. Having bought DROPS yarn, you are guaranteed to receive qualified help from a store specializing in the DROPS patterns. You can also take a look at our tutorial videos.

All patterns are carefully reviewed, but we must make reservation for possible mistakes. All patterns are translated from Norwegian and you can always check the original pattern for measurements and calculations. Go to original pattern for design DROPS 87-1. If you think you have found an error in the pattern, please post your remark or question in our Comments section.

© 1982-2014 DROPS Design A/S. We reserve all rights. This document, including all its sub-sections, has copyrights. This is for all of you with knitting as a hobby and for you who run a yarn store. Either way, the DROPS pattern database is at your free disposal. As a store you are welcome to use the DROPS pattern database to promote the sale of your assortment. Print out any pattern you may want, make as many copies as desired. The only thing we ask is that you don't make any changes / additions to the original printed document... and that the patterns according to the DROPS philosophy are given out to the consumers for free.
The sale of garments based on DROPS DESIGN is permitted as long as they are sold as single items or per order. Further commercial use of the patterns is not permitted. It has to be clearly stated that the garment is made based on a design from DROPS DESIGN. The use of DROPS photos for marketing purposes/sales is only permitted when only DROPS yarns have been used. The photo may not be cut or edited and the logo should be clearly visible. The use of clothes labels of which DROPS DESIGN forms part is conditioned by the inclusion of the following text: “A DROPS DESIGN made by …..”.
We reserve the right to withdraw the permission for use at any time, notwithstanding the reason.

DROPS Design