Carol Maitland wrote:
Hi I would like to make the above pattern in Andes or Snow do I use a double strand on both or single strand.I made this in Polaris,the cowl was perfect but the hat was way too big. Thks Carol Maitland.
06.01.2023 - 16:54DROPS Design answered:
Hello Carol Maitland! This pattern is written for 2 threads in Andes/Snow. If you want to make it lighter, you could always choose stitch count from other tutorials and use this diagonal pattern for lines. Mix and match! Happy knitting!
06.01.2023 - 22:43Carol Maitland wrote:
Hi just finished this pattern for my daughter,Idid do one less pattern repeat and it turned out better than the last time,smaller.Now my question is I have noticed that the bottom of the cowl and the hat the ends curl,why would this be and do you have a solution.\r\n\r\nThks,Carol
09.07.2022 - 17:53DROPS Design answered:
Dear Carol, it seems to be a problem with the gauge. This may sometimes happen, especially if you use different needles. You could try to fix it by ironing it with steam to try to flatten it. Happy knitting!
15.07.2022 - 12:39Carol Maitland wrote:
Hi,I recently made this hat for my daughter,the cowl was fine but the hat was too big.i am new to knitting so what size needle should I use .thks carol.
22.04.2022 - 19:38DROPS Design answered:
Dear Carol, if the hat is too big due to your knitting gauge, you should use a smaller needle, for example 7mm. However, it may be difficult to work with Polaris with such a small needle. You could instead work 1 less repeat of the 6-stitch pattern, so that the end result is slightly smaller. Happy knitting!
23.04.2022 - 16:37Sharon wrote:
Hi! Will be using anders to make the hat. Do I use / threads or one? Thanks for responding. S
21.11.2021 - 09:45DROPS Design answered:
Dear Sharon, if you are using the Andes yarn, you will need to use two strands at once. Happy Stitching!
21.11.2021 - 14:54Carol Maitland wrote:
Hi I have made the above pattern.The rep told me to check my tension as I feel the hat is to big.I used 49 stitches for small/medium.Would it be ok to use 7mm instead of the 8mm. Thks carol.
23.10.2021 - 17:51DROPS Design answered:
Dear Carol, you should always make a sawtch, check your gauge, and recalculate stitch numbers accordingly if necessary. Generally, using smaller needles will result a smaller, but denser piece. Happy Stitching!
24.10.2021 - 03:09Carol Maitland wrote:
Hi I sent in a question above and the rep told me to check my tension,that being said how about if I use 7 mm dpn for the hat instead of the 8 mm,would this make the hat smaller.thks again.Carol.
23.10.2021 - 01:52DROPS Design answered:
Dear Carol, using a smaller needle would result a smaller, but at the same time denser, lest soft piece. Happy Stitching!
24.10.2021 - 02:57Carol Maitland wrote:
Hi I have just finshed this pattern the cowl and hat.My problem is the hat,I used 49 stitches for small/medium and the finished product still looks big.I have yet to get my daughter to try it it may fit.Is it possible to use smaller needles for this pattern.thsk carol.
22.10.2021 - 16:20Elke K wrote:
Frage zum Pompom, der Durchmesser soll 15 cm sein, welchen Durchmesser hat der innere Kreis von der Schablone? Was bedeutet lockerer Pompom? Vielen Dank für Ihre Antwort
10.12.2020 - 17:21DROPS Design answered:
Liebe Elke, dieses Video zeigt, wie man ein Pompon macht - der innere Kreis kan ca 1/3 kleiner, dh hier 3 cm - aber am besten versuchen Sie, wie Sie es am besten möchten. Viel Spaß beim stricken!
11.12.2020 - 13:04Nina Writz wrote:
Cupcake spiral hat pattern 151 - 43 The Spiral pattern SPIRAL PATTERN: Work * K 4, P 2*, repeat *-* around. The pattern repeat goes over 6 sts and the stitch number can be divided by 6 + 1. When working in the round the pattern will automatically shift 1 st to the right for each round and creates a spiral pattern. I do know understand how it can spiral and not be a rib stitch. I must be misunderstanding the pattern. Thank you for your time. Nina
03.09.2020 - 21:33DROPS Design answered:
Dear Mrs Writz, the pattern is worked in the round, without changing the way to work the stitches at the end/beg of the round, this means you will work (K4, P2) all the way, since the pattern is worked over 6 sts and since the number of sts is divisible by 6+1, the (K4, P2) will automaitcally be shifted. See also the video below. Happy knitting!
04.09.2020 - 08:02
Cupcake |
|
|
|
Komin i czapka DROPS ściegiem fantazyjnym w spiralę, 1 nitką włóczki „Polaris” lub 2 nitkami włóczki „Snow” lub „Andes”.
DROPS 151-43 |
|
WSKAZÓWKA DO ZMIANY MOTKA: Aby zmienić kłębek przerabiając włóczką Polaris, należy podzielić nitkę na 2 części na końcu motka na dł. 15 ost. cm – odciąć jedną część i zrobić to samo na pocz. drugiego motka. Złożyć razem 15 pierwszych i 15 ost. cm, nitka ma w ten sposób normalną grubość i przerabiać. Dzięki temu zmiana motka będzie niewidoczna. ŚCIEG FANTAZYJNY W SPIRALĘ: Przer. *4 o.p., 2 o.l.*, powt. od *-* całe okrążenie. Ścieg fantazyjny jest powtarzany na 6 o. a liczba o. to wielokrotność 6 + 1. Gdy przerabiamy na okrągło, motyw automatycznie będzie się przesuwał o 1 o. w prawo w każdym okr. i uformuje spiralę. ---------------------------------------------------------- CZAPKA: Nabrać 49-55 o. na druty pończosznicze nr 8 1 nitką włóczki Polaris lub 2 nitkami Snow i przer. na okrągło. Przer. 1 okr. na prawo przez wszystkie oczka, dalej przerabiać ŚCIEGIEM FANTAZYJNYM W SPIRALĘ – patrz powyżej, aż dł. robótki wynosi ok. 17-18 cm – PATRZ WSKAZÓWKA DO ZMIANY MOTKA! Przer. 1 okr. na prawo, umieścić 6 markerów: pierwsze pięć co 8-9 o., a przed ostatnim jest 9-10 o. Dalej przer. dżersejem, W TYM SAMYM CZASIE w 1-szym okr. zamknąć 1 o. po prawej stronie każdego markera przerabiając 2 o. razem na prawo, powt. zamykanie o. jeszcze 4-5 razy co 2 okr. (= w sumie 5-6 razy) = 19-19 o. W nast. okrążeniu przer. każde 2 kolejne o. razem na prawo przez całe okr. = 9-9 o. Odciąć nitkę i przeciągnąć ją przez pozostałe o., zacisnąć i zakończyć. POMPON: Wykonać duży dosyć luźny pompon o średnicy ok. 15 cm i zamocować go na górze czapki. ---------------------------------------------------------- KOMIN: Na druty z żyłką nr 8 nabrać 55-61 o. 1 nitką włóczki Polaris lub 2 nitkami Snow i połączyć na okrągło. Przer. 1 okr. na prawo przez wszystkie oczka. Umieścić 1 marker na początku okrążenia, a dalej przer. ŚCIEGIEM FANTAZYJNYM W SPIRALĘ – patrz powyżej, aż dł. robótki wynosi ok. 17-21 cm – PATRZ WSKAZÓWKA DO ZMIANY MOTKA! Dalej przer. 1 okr. na prawo i zakończyć. Wys. robótki wynosi ok. 18-22 cm. |
|
Czy wykonałaś ten lub inny z naszych wzorów? Otaguj zdjęcia na portalu społecznościowym #dropsdesign, abyśmy mogli je zobaczyć! Potrzebujesz pomocy w związku z tym wzorem?Zobacz instrukcje video, sekcję Komentarze/Pytania i jeszcze więcej, wchodząc na stronę wzoru na garnstudio.com © 1982-2024 DROPS Design A/S. Wszelkie prawa zastrzeżone. Ten dokument, w całości, jest chroniony prawem. Zobacz co możesz robić z naszymi wzorami na dole każdego wzoru na naszej stronie. |
Ricarda wrote:
Vor einiger Zeit fragte jemand, ob man die Mütze auch "im Muster", statt glatt rechts bis oben stricken kann. Ja, das geht und natürlich auch das Stricken mit einer Rundstricknadel. In der Anleitung DROPS Extra / 0-1045 wird erklärt, wie man im Spiralmuster abnimmt, man muss es nur anpassen und darauf achten, dass die Spirale andersherum läuft!
08.12.2021 - 01:22