Sideway Vines |
|||||||||||||
|
|
||||||||||||
Knitted beret and mittens with Nordic pattern in DROPS Karisma.
DROPS 204-15 |
|||||||||||||
------------------------------------------------------- EXPLANATIONS FOR THE PATTERN: ------------------------------------------------------- PATTERN: Beret: See diagram A.1. Mittens: See diagrams A.2 and A.3. The whole pattern is worked in stockinette stitch. DECREASE TIP (evenly spaced): To work out how to decrease evenly, count the total number of stitches on needle (e.g. 112 stitches) and divide by number of decreases to be made (e.g. 4) = 28. In this example decrease by knitting each 27th and 28th stitch together. KNITTING TIP-1: To avoid the knitting gauge becoming tighter when working pattern, it is important that the strands at the back are not tight. You can use a larger size needle when working pattern if this is a problem. KNITTING TIP-2 (for mittens): If you would like the mittens to have a larger circumference you can use a size, or a half-size, larger needles. A half-size larger will give approx. 1 cm = ⅜" more in circumference and a full size will give approx. 2 cm = ¾" more in circumference. KNITTING TIP-3 (for mittens): The length before you start the thumb can be adjusted by working more or fewer rounds before marking the thumb opening. DECREASE TIP-1 (for top of mitten): Decrease 1 stitch on each side of the marker as follows: Start 3 stitches before the marker, knit 2 together, knit 2 (the marker sits between these 2 stitches), slip 1 stitch as if to knit, knit 1 and pass the slipped stitch over the knitted stitch (= 2 stitches decreased at the marker and a total of 4 stitches decreased on the round). DECREASE TIP-2 (for thumb): Decrease 1 stitch on each side of the marker as follows: Start 2 stitches before the marker, knit 2 together, marker, slip 1 stitch as if to knit, knit 1 and pass the slipped stitch over the knitted stitch (= 2 stitches decreased at the marker and a total of 4 stitches decreased on the round). ------------------------------------------------------- START THE PIECE HERE: ------------------------------------------------------- BERET – SHORT OVERVIEW OF THE PIECE: The piece is worked in the round with short circular needle, bottom up. Change to double pointed needles when necessary. BERET: Cast on 104-112 stitches with short circular needle size 3 mm = US 2,5 and petrol. Knit 1 round then work rib in the round (= knit 2 / purl 2) for 3-4 cm = 1⅛"-1½". Change to short circular needle size 3.5 mm = US 4 and knit 1 round with petrol where you decrease 2-4 stitches evenly spaced – read DECREASE TIP = 102-108 stitches. Read KNITTING TIP-1 and work A.1 in the round (= 17-18 repeats of 6 stitches). Increase as shown in the diagram = 170-180 stitches on the needle. REMEMBER THE KNITTING GAUGE! AT THE SAME TIME on the rounds marked with arrows in A.1, decrease stitches evenly spaced as described below: Arrow-A: Decrease 20-20 stitches evenly spaced = 150-160 stitches. Arrow-B: Decrease 20-20 stitches evenly spaced = 130-140 stitches. Arrow-C: Decrease 30-30 stitches evenly spaced = 100-110 stitches. Arrow-D: Decrease 30-30 stitches evenly spaced = 70-80 stitches. When A.1 has been worked in height continue with petrol AT THE SAME TIME as you decrease as follows: * Knit 1 round then knit 1 round where you decrease 18-20 stitches evenly spaced *, work from *-* a total of 3 times (each time you decrease you work 1 stitch less before knitting 2 together) = 16-20 stitches left. Knit 1 round then knit 1 round where all stitches are knitted together 2 and 2 = 8-10 stitches left. Cut the strand, pull it through the remaining stitches, tighten and fasten well. The beret measures approx. 21-22 cm = 8¼"-8¾" from mid top and down to the cast-on edge. ------------------------------------------------------- MITTENS – SHORT OVERVIEW OF THE PIECE: The piece is worked in the round with double pointed needles, bottom up. The circumference is the same in both sizes, but the length is different. The circumference can be adjusted – read KNITTING TIP-2! LEFT MITTEN: Cast on 50-50 stitches with double pointed needles size 3 mm = US 2,5 and petrol. Work 8 rounds of stockinette stitch for the lining. The next round is worked as follows: * Knit 2 together, make 1 yarn over *, work from *-* to end of round (= folding-edge). Insert 1 marker thread on the round; the piece is now measured from here. Work 8 rounds of stockinette stitch with petrol. Read KNITTING TIP-1 and then work A.2 in the round (= 5-5 repeats of 10 stitches). REMEMBER THE KNITTING GAUGE! When the piece measures approx. 11-12 cm = 4⅜"-4¾" from the marker thread (adjust so the next round is one-colored), work a marking of the thumb-opening as follows – read KNITTING TIP-3: Work 15 stitches stockinette stitch with petrol, 8 stitches stockinette stitch for the thumb-opening using a contrasting color, then the remaining 27 stitches stitches in stockinette stitch with petrol. Then continue the pattern as before over all the stitches. When the piece measures approx. 21-23 cm = 8¼"-9" from the marker thread, start to decrease at the top of the mitten (there is approx. 3 cm = 1⅛" left to finished length; you can try the mitten on and continue to desired length). Insert 1 marker at the beginning of the round and 1 marker after 25-25 stitches. On the next round decrease 1 stitch on each side of both markers - read DECREASE TIP-1. Decrease like this every round a total of 11 times in both sizes = 6-6 stitches left. Cut the strand, pull it through the remaining stitches, tighten and fasten well. The mitten measures approx. 24-26 cm = 9½"-10¼" from the top down to the marker thread on the folding-edge. THUMB, LEFT MITTEN: Pull out the strand worked over the 8 stitches for the thumb-opening and place the stitches on double pointed needles size 3 mm = US 2,5. In addition, knit up 1 stitch in each of the 8 stitches cast on over the thumb opening and 1 stitch on each side of the thumb (with petrol) = 18 thumb stitches on the needles. Remember KNITTING TIP-1 and work A.3 in the round. When the thumb measures approx. 5-5½ cm = 2"-2⅛", start to decrease at the top of the thumb (there is approx. 1 cm = ⅜" left to finished length; you can try the mitten on and work the thumb to desired length). Insert 1 marker on each side of the thumb so there are 9 stitches on each side of both markers. On the next round decrease 1 stitch on each side of both markers - read DECREASE TIP-2. Decrease like this every round a total of 3 times = 6 stitches left. Cut the strand, pull it through the remaining stitches, tighten and fasten well. The thumb measures approx. 6-6½ cm = 2⅜"-2½" from the top down. RIGHT MITTEN: Cast on 50-50 stitches with double pointed needles size 3 mm = US 2,5 and petrol. Work 8 rounds stockinette stitch for the lining. The next round is worked as follows: * Knit 2 together, make 1 yarn over *, work from *-* to end of round (= folding-edge). Insert 1 marker thread on the round; the piece is now measured from here. Work 8 rounds stockinette stitch with petrol. Then work A.2 in the round (= 5-5 repeats of 10 stitches). When the piece measures approx. 11-12 cm = 4⅜"-4¾" from the marker thread (adjust to match the left mitten) work a marking of the thumb-opening as follows: Work 27 stitches in stockinette stitch with petrol, 8 stitches stockinette stitch for the thumb-opening with a contrasting color then the remaining 15 stitches in stockinette stitch with petrol. Then continue the pattern as before over all stitches. When the piece measures approx. 21-23 cm = 8¼"-9" from the marker thread, start to decrease at the top of the mitten (adjust the length to match the left mitten). Insert 1 marker at the beginning of the round and 1 marker after 25-25 stitches. On the next round decrease 1 stitch on each side of both markers - read DECREASE TIP-1. Decrease like this every round a total of 11 times in both sizes = 6-6 stitches left. Cut the strand, pull it through the remaining stitches, tighten and fasten well. The mitten measures approx. 24-26 cm = 9½"-10¼" from the top down to the marker thread on the folding-edge. THUMB, RIGHT MITTEN: Work the thumb in the same way as the thumb on the left mitten. ASSEMBLY: Fold the lining in towards the wrong side and fasten with small neat stitches. |
|||||||||||||
Diagram explanations |
|||||||||||||
|
|||||||||||||
Have you made this or any other of our designs? Tag your pictures in social media with #dropsdesign so we can see them! Do you need help with this pattern?You'll find tutorial videos, a Comments/Questions area and more by visiting the pattern on garnstudio.com. © 1982-2024 DROPS Design A/S. We reserve all rights. This document, including all its sub-sections, has copyrights. Read more about what you can do with our patterns at the bottom of each pattern on our site. |
Comments / Questions (21)
Damaris wrote:
Wo bekomme ich das Strickmuster?
01.02.2021 - 21:48DROPS Design answered:
Liebe Damaris,hier finden Sie die ganze Anleitung auf Deutsch mit dem Strickmuster. Viel Spaß beim stricken!
02.02.2021 - 10:49Monika wrote:
Dzień dobry ,Według schematu beretu są dwa miejsca dodawania oczek ,u mnie po dodaniu na drutach jest 141 oczek w opisie 170 oczek, gdzie popełniam błąd?
10.01.2021 - 19:43DROPS Design answered:
Witaj Moniko, w rozmiarze S/M przed rozpoczęciem schematu masz 102 oczka. Następnie przerabiasz schemat A.1 i powtarzasz go 17 razy w okrążeniu. W każdym powtórzeniu schematu A.1 dodanych jest łącznie 4 oczka> 17x4=68 dodanych oczek. 102+68=170 oczek. Pozdrawiamy!
10.01.2021 - 20:27Frøy wrote:
Anna Olsson: Du skal strikke vottene med diagram 2, ikke 1! Håper du ser dette :) Hilsen Frøy
08.01.2021 - 15:57DROPS Design answered:
Tusind tak Frøy :)
11.01.2021 - 13:09Anna Olsson wrote:
Hej när jag ska sticka vantarna är det ju 50 maskor fördelat på fyra stickor, men på mönsterrapporten A1 ser det ju ut att vara "bara" 6 maskor och att det ökas på med omslagen. Jag får till för många maskor när jag ska börja med mönsterfärgen......typ tre för många . Vad gör jag för fel?
08.01.2021 - 12:17DROPS Design answered:
Hej Anna, som Frøj også har svaret dig, skal du strikke vanterne efter diagram A.2 - God fornøjelse!
11.01.2021 - 13:11Viviann KRlsbakk wrote:
Hei. Begynte å strikke denne baskerlua. Om eg følger mønsteret, og auker slik det står får eg 20 masker mindre enn eg skal? Fint om eg kan få tilbakemelding på dette?
29.01.2020 - 10:25DROPS Design answered:
Hej Viviann, mener du når du øger ifølge diagrammet? Hvilken størrelse strikker du? Hvor mange masker har du når du starter og hvor mange har du når du har taget ud ifølge diagrammet?
31.01.2020 - 09:26Marie-Line wrote:
Bonjour, pour la moufle après les 12cm les 8 mailles sont-elles mises sur un arrête mailles et tricotée ensuite ??? Merci.
01.01.2020 - 12:12DROPS Design answered:
Bonjour Marie-Line, on tricote ces mailles avec un autre fil d'une autre couleur et on les reprendra ensuite en enlevant le fil - comme on le montre dans cette vidéo. Bon tricot!
02.01.2020 - 15:09Frøy wrote:
Takk, men jeg tenkte mer på fallet/tyngden i garnet …
31.10.2019 - 09:24DROPS Design answered:
Hej Frøy, jo men bliver lige så fint i DROPS Lima :)
31.10.2019 - 10:05Frøy wrote:
Helt nydelig sett! Denne blir vel bra i Lima også?
30.10.2019 - 17:20DROPS Design answered:
Hej. Ja du kan sticka detta set i Lima (som också tillhör garngrupp B), tänk bara på att få riktig stickfasthet som vanligt. Lycka till!
31.10.2019 - 06:55Nette Strickerin wrote:
Wie fein, aus der Basenmütze wurde eine Baskenmütze :)) Daumen hoch!!!
16.10.2019 - 21:37Ela wrote:
Liebes Team, herzlichen Dank für die Anleitung! Vielleicht möchten Sie gern in der Überschrift die "Basenmütze" in "Baskenmütze" ändern? ;)) Liebe Grüße, Ela!
08.10.2019 - 17:55