DROPS VIVALDI UNI COLOUR (50g)
DROPS VIVALDI UNI COLOUR (50g)
NOTE: This pattern is written in British English. All measurements in charts are in cm. For conversion from cm to inch - click here.
There are different terms for crocheting in British and American English. If this pattern includes crochet, click for "crochet terms" here.
Tension: 10 sts x 16 rows on needle size 8 mm with 1 thread Highlander + 1 thread Vivaldi and stocking stitches = 10 x 10 cm.
Garter sts (back and forth on needles): 1st row: Knit, 2nd row: Knit.
Decreasing tip (applies to neck line): All dec are made from RS! Dec within 5 sts of front band + the inc sts for collar.
Dec like this before the sts in garter sts: K2 tog.
Dec like this after the sts in garter sts: Slip next st as if to knit, K1, psso.
Back piece: Cast on 50 (54) 58 (63) 67 sts on needle size 7 mm with 1 thread Highlander + 1 thread Vivaldi and work 4 rows in garter sts. Change to needles size 8 mm and continue with stocking sts and 3 sts in garter sts in each side (= split). Remember to check your knitting tension! When piece measures 15 cm splits stops and cast on 1 new st each side (= edge st to sew in afterwards) = 52 (56) 60 (65) 69 sts. Continue with stocking sts over all sts.
When piece measures 20 cm and then 38 cm dec 1 st each side = 48 (52) 56 (61) 65 sts.
When piece measures 56 (57) 58 (59) 60 cm dec for armholes each side on every other row: 3 sts 1 time, 2 sts 0 (0) 1 (2) 2 times and 1 st 2 (3) 3 (3) 4 times = 38 (40) 40 (41) 43 sts.
When piece measures 74 (76) 78 (80) 82 cm cast off center 8 (8) 8 (9) 9 sts for neck. On next row cast off additional 1 st towards neck = 14 (15) 15 (15) 16 sts rem on each shoulder. Cast off when piece measures 76 (78) 80 (82) 84 cm.
Left front piece: Cast on 30 (32) 34 (37) 39 sts (incl 5 sts as front band) on needle size 7 mm with 1 thread Highlander + 1 thread Vivaldi. Work 4 rows in garter sts - NOTE: First st towards mid front slips in beg of every row until finished measure, in the end of row knit this st. Change to needle size 8 mm and work stocking st with 5 edge sts in garter st towards mid front and 3 sts in garter st in side (= split). When piece measures 15 cm split stops and cast on 1 new st in side (= edge st to sew in afterwards) = 31 (33) 35 (38) 40 sts. Continue in stocking st and front band in garter st. When piece measures 20 cm and then 38 cm dec in side as on back piece = 29 (31) 33 (36) 38 sts.
Read whole following section before you knit!
Armhole: When piece measures 56 (57) 58 (59) 60 cm dec for armhole in side as on back piece.
Collar: At the same time cast on 12 new sts towards mid front to collar. Now keep slipping the first st on row and work following 16 sts in garter st (the other sts in stocking st).
Neckline: At the same time when piece measures 58 (59) 60 (61) 62 cm dec 1 st towards neck line on every other row: 8 (8) 8 (9) 9 times and on every 4th row: 2 times - read Dec.tip.
After all dec for armhole and neck there are 26 (27 (27 (27) 28 sts remaining on needle.
Continue until piece measures 76 (78) 80 (82) 84 cm. Now cast off 14 (15) 15 (15) 16 sts on shoulder = 12 collar sts in garter st remaining on needle.
Collar: Continue to work in garter st over the collar as follows: * 2 rows garter st over all sts, 2 rows garter st over only the outermost 8 sts towards mid front *, repeat *-* until collar measures approx 5 (5) 5 (6) 6 cm farthest in (approx 10 (10) 10 (12) 12 cm farthest out).
Put sts on a thread or stitch holder.
Right front piece: Cast on and knit as left, but cast off for armhole and neck in opposite side. Dec for button holes along front band. 1 button hole = knit 3rd and 4th sts from mid front tog, YO. On next row K yo twisted, so that the hole doesn’t get too big.
Make button holes when piece measures:
Size S: 20, 29, 38, 47, 56 cm,
Size M: 20, 30, 39, 48, 57 cm,
Size L: 20, 28, 35, 43, 51, 58 cm,
Size XL: 20, 28, 35, 43, 51, 59 cm,
Size XXL: 20, 28, 36, 44, 52, 60 cm.
Sleeves: Cast on 26 (28) 30 (30) 32 sts (incl 1 edge st each side) on needle size 7 mm with 1 thread Highlander + 1 thread Vivaldi and work garter st for 14 cm. Change to needle size 8 mm and continue in stocking st. At the same time after garter st inc 1 st each side on every 6½ (6) 5 (4) 4 cm a total of 6 (6) 7 (8) 8 times = 38 (40) 44 (46) 48 sts.
When sleeve measures 49 (48) 47 (45) 44 cm cast off for top shaping in each side on every other row: 3 sts 1 time, 2 sts 1 time and 1 st 2 (3) 4 (5) 6 times, then cast off 2 sts each side until piece measures 56 cm, at last cast off 3 sts 1 time in each side.
Cast off the remaining sts, piece measures approx 57 cm.
Assembly: Sew shoulder seams. Sew collar tog mid back with small stitches and sew on the collar towards neck line back. Sew in sleeves. Sew sleeve- and side seams in one within 1 edge sts down to split. Sew in the buttons.
Belt: Cast on 5 sts on needle size 7 mm with 1 thread Highlander + 1 thread Vivaldi and work garter st until belt measures approx 120-150 cm, cast off.
Embroidery: Sew stitches on cuffs between garter st and stocking st and along the collar with Vienna as follows: Cuff: Sew with double thread over 6 rows in garter st in height and 2 sts in width.
Collar: Start like this to avoid to fasten threads mid front: start at one side in front of long side on the collar. Pull 1 thread Vienna through the collar in outermost garter st row, 3 sts from edge, make the thread double (= 2 threads). Then sew over 4 garter st rows in height and 3 sts in width to mid back in neck and then down along seam mid back. Repeat at the other side of the collar (there will be cross stitches mid back).
Size: S/M (M/L)
Materials: DROPS Eskimo, from Garnstudio
100 g brown (nr 03)
and use: DROPS Vienna, from Garnstudio
50 g maroon (nr 10)
Needle size 10 mm.
Tension: 8½ sts x 11 rows on needle size 10 mm with 1 thread Eskimo + 1 thread Vienna and stockinette st = 10 x 10 cm.
Hat: Cast on 42 (45) sts on needle size 10 mm with 1 thread of each quality.
K1 row from WS, continue in stocking st. When piece measures 12 cm (adjust so that next row works from RS) place 6 (5) marking threads as follows: first marking thread after 1 st, place the following with 7 (9) sts between each st, after last marking thread there are 6 (8) sts. On next row K2 tog on left side of all marking threads, repeat dec on every other row a total of 6 (8) times = 6 (5) sts remaining on needle. Cut the thread and pull through the remaining sts, pull tog and fasten. Whole hat measures approx 22 (26) cm up to the top. Sew hat tog, sew in the outermost stitch loops so that seam doesn’t get bulky.
Measure: approx 39 cm x 2 meter
Materials: DROPS Vienna, from Garnstudio
150 g maroon (nr 10)
Needle size 10 mm.
Tension: 10 sts x 14 rows on needle size 10 mm and rib = 10 x 10 cm.
Rib: * K3, P3 *, repeat *-*.
Scarf: Cast on 39 sts loosely on needle size 10 mm. Work in rib with 3 sts in garter st in each side. When piece measures approx 2 meter, cast off in rib.
Do you need some help?
For further pattern help, please contact the store where you bought the yarn. Having bought DROPS yarn, you are guaranteed to receive qualified help from a store specializing in the DROPS patterns. You can also take a look at our tutorial videos.
All patterns are carefully reviewed, but we must make reservation for possible mistakes. All patterns are translated from Norwegian and you can always check the original pattern for measurements and calculations. Go to original pattern for design DROPS Extra 0-375. If you think you have found an error in the pattern, please post your remark or question in our Comments section.
© 1982-2014 DROPS Design A/S. We reserve all rights. This document, including all its sub-sections, has copyrights. This is for all of you with knitting as a hobby and for you who run a yarn store. Either way, the DROPS pattern database is at your free disposal. As a store you are welcome to use the DROPS pattern database to promote the sale of your assortment. Print out any pattern you may want, make as many copies as desired. The only thing we ask is that you don't make any changes / additions to the original printed document... and that the patterns according to the DROPS philosophy are given out to the consumers for free.
The sale of garments based on DROPS DESIGN is permitted as long as they are sold as single items or per order. Further commercial use of the patterns is not permitted. It has to be clearly stated that the garment is made based on a design from DROPS DESIGN. The use of DROPS photos for marketing purposes/sales is only permitted when only DROPS yarns have been used. The photo may not be cut or edited and the logo should be clearly visible. The use of clothes labels of which DROPS DESIGN forms part is conditioned by the inclusion of the following text: “A DROPS DESIGN made by …..”.
We reserve the right to withdraw the permission for use at any time, notwithstanding the reason.